Forgot your password?
Forgot your username?
Chat in the 'Virtual' Pub, reminisce in the History Archive, mooch around projects in The Garage or maybe participate in a bit of Tech.
Why not register and give it a try. Did we mention it was FREE ???
Post a reply to the thread: Ford 289 running issues.
Send Trackbacks to (Separate multiple URLs with spaces)
You may choose an icon for your message from this list
Please enter the name by which you would like to log-in and be known on this site.
Please enter a password for your user account. Note that passwords are case-sensitive.
Please enter a valid email address for yourself.
Where you live, Town\City\County etc.
Please enter your full name
This field cannot be edited once it has been completed other than via contacting the site admin. Please make sure the information is correct first time.
Will turn www.example.com into [URL]http://www.example.com[/URL].
Bought it!!! Can't get it to work!!! Lol. Anyway found a black wire going to the negative on the coil coming from the loom. Don't know what it is. Pulled it off and fired straight up. Ran fine for. 5 mins then just dropped its revs and wouldn't rev up. Just ticked over lumpy. Tried to rev and would die. Then cut out. Then found the bottom of the rad leaking. Looked over cooling system and the stat housing is leaking as well. Top and bottom house rock hard and hot. Core of the rad cold. Blockage somewhere.
Went to turn over and battery flat do alternator not charging. So engine ford because. 1/ overheated. 2/ not enough power in battery to power the coil or combination of both.
And so it goes on!!!! Lol
I hate cars!!!
Joe, here is the address of a supplier of electrical gubbins,
Toolstation UK Ipswich
Quantum Business Park,
White House Road,
A very basic tester , 84459 Car Light Tester 6V - 24V @ £2
Or a better bet is a meter ,
11867 Digital Multi Meter @ £5.90
To answer your last point, yes, if you had a plus and minus connected all the time, a coil would die. But you don't. The plus is connected all the time but the negative is switched, via the points. Some more reading for you. Distributor - Wikipedia, the free encyclopedia
If you connect a wire from ign to the coil, and a wire from start to the solenoid it will run.
No I don't have a voltmeter I need to get one. Electricity has always frightened me so I've stayed away!! Lol
I thought running a constant live from the battery to the coil would kill the coil?
do you have multimeter? the coil you have requires full voltage at all times, ie no resistance wires or ballast resistors.
Just a thought, I had a similar problem with a Volvo 1800 s once and it turned out to be the rev counter ( wired into ) the coil feed and was breaking down) Try rigging a wire directly from battery to coil as Sidspop says.
Run another wire from the start position of the ignition to the solenoid.
I've got the correct accuspark non ballast (red) coil that goes with the electronic ignition. If I wire the ignition direct to the coil and bypass the solenoid how will the starter turn when I turn the key?
It isnt Barry... lol
what coil are you using? make & part number?
Why don't you do the simple thing?
Put a 12 volt coil on it. Run a new separate wire from the IGN terminal on the back of the switch.
sounds like you're wired for a ballast resistor. the solenoid feeds a full 12v to the ballasted normally 9v ish coil when cranking to give a hotter spark on startup. wire the 12v ign' live straight to the coil plus side and try it (didn't i already suggest that?). neil.
Terms and Conditions