looks hard as nails biff

Looks real tough mate, prefer it without the flames

Originally Posted by TheOldShedSquad

Yeah, nice one, Biff! I do like to see video of a bloke thumbing his own flaps open ...
Or perhaps not.

So when'll you be out on the strip?

money is exceptionally tight at the moment, so most likely it will be next season....i am hoping to get to the hotrods and hills though if i do, i wont be doing the cruise.

Yeah, nice one, Biff! I do like to see video of a bloke thumbing his own flaps open ...
Or perhaps not.

So when'll you be out on the strip?

lookin great biff ..

I think this might work

<embed width="600" height="361" type="application/x-shockwave-flash" allowFullscreen="true" allowNetworking="all" wmode="transparent" src="http://static.photobucket.com/player.swf" flashvars="file=http%3A%2F%2Fvid448.photobucket.co m%2Falbums%2Fqq206%2Fstevespicsnstuff%2F20120605_1 40247.mp4">
perhaps this might?

http://s448.photobucket.com/albums/q...605_140247.mp4

Well, it's been a long time since the old girl turned a wheel, but today, a ****y wet day, i drove her for a few miles, (the first time since August last year when i blew the diff)
while she was off the road, i fitted new fibreglass front end sheet metal?, raised the suspension a couple of inches to clear speed bumps, new carbs and exhaust etc.

here are a few pics, and if i can ever figure out how to upload a video from my phone, i'll do that too.

Great to hear you're making progress mate, good news about the MOT, good luck !!

Update time, ......rad sorted (and more to the point, NO LEAKS), waterpump, fans and fan switch wired up, new screen fitted, ariel fitted, fuel leak sorted...........looking to take it for MOT sometime this week !

A little update on the camaro.......
spent the day making mounts for the new radiator, because of the height of the new rad, and the lowered stance, i've had to lay the rad back a little so that the cap doesnt need a bulge in the bonnet.
This causes a little problem in that the bottom outlet is now ay too close to the lower arm





now i'm gonna have to cut off the outlet and have it re-welded at a more suitable angle !