beam axle and rear end

[Duncan]

looking for a complete pop axle wishbone spring or two hubs etc
or a strait tube etc to suit 100e width also rear end of some discription nine inch eight inch ten bolt whatever prefer allready shrtend to reasonably small width need ladder bars aswell and anything else interesting for gasser project .

[40Stude]

Magman on here (see the Garage section) has a narrowed eight inch that he is replacing with a nine inch. Try sending him a pm to see if it's for sale.

[fozwanger]

looking for a complete pop axle wishbone spring or two hubs etc
or a strait tube etc to suit 100e width also rear end of some discription nine inch eight inch ten bolt whatever prefer allready shrtend to reasonably small width need ladder bars aswell and anything else interesting for gasser project .

AcePop has a complete pop beam, come with half chassis still attached. I have an MGB axle (Salisbury) 50" I think.

Mind you, bit of a trek eh?

[Duncan]

bump still looking

[loon]

hi duncan
iv got a volvo 240 axle narowed 10" by bob nixon with 4.10-1 gears, new outer bearings, with batwings and 31" laderbars polybushed and coil over mounts with XJ12 coilovers
and the halfsharft ends have been changed to jag chev, all that's left to do is get new discs (redrilled) n pads
i think it's about 49" wide, any good?

[Duncan]

possibly how much you wantin

[loon]

http://i132.photobucket.com/albums/q...on/p100034.jpg

its 46.5" wide and the laderbars are 32" long
£370 but it cost more than that,
and i can drop it off at andy's or i can take it to the supernats if you want it.

[Duncan]

naa ill leave it as i may want to double duty my big block into this motor and i want the rear end to cope.