Just spent another 2hours messing about with my clutch system bleeding it through to no avail. Decided to take the slave cylinder off and found the pushrod to the release fork had dropped off. Sore left foot from hours of bleeding and the rod wasnt linked!
Furthur tinkering resulted in the whole lever assembly dropping off its pivot. :****er:
So, my question, is this box out time to reconnect the clutch pivot to reconnect the push rod. Ive heard that its best to modify the release arm with a washer so the rod dosent drop off again wilst its out too.
Fingers crossed theres a way of getting it back into location but I expect not somehow.
Its a standard SD1 Rover V8 setup with manual box....obviously!