not done a build thread for a long time.mostly because I havnt had any builds in that warrented their own thread.
have a couple of biggies to do soon so will post them up in the garage section.
what I do get is plenty of randomness,so this is about them and the problems faced when building one offs,and how ive bodged them back together.
this is low budget stuff,so don't expect show quality though I will try and post good clear pics.
ill try and backdate a little bit if I get time but have these two to play with at the moment
first of a 35 chevy.its in for sorting the rear end out.its been in previously to have the steering done.
on the first occation the steering wheel was sloppy as hell.
turns out the pivot points rack end bits, in the rack needed either changing or re pre loading but it was never done.so in the end the over compensationg or vibration while steering took out all the ujs and even the column ended up with play in it.
the rear end.owner said rear was hard.exhaust ran through between the chassis and spring but was acually wedged between them so there was no suspension travel
then this turned up with a bed full off parts.everything had been started but nothing had been finished.id list what needs doing but it would take the page up.
nice looking truck
![]()
Bookmarks