Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner

cable

  1. Tech Discussion
    Hi Guys I have a Holley 4160 with the throttle cable roughly pinched onto the carbs throttle arm by a bolt and 2 washers. Not very nice and has no freedom of movement. I have been trying to source a simple cable end pivot arm with a small pinch screw for the cable but I have had no joy :(...
  2. Stuff - WANTED
    Has any of you hot rodders got such a thing as a gm 180 speedo,the bit that connects to the gearbox and drives a cable not the electronic one cheers for now
  3. Tech Discussion
    Hi All Anybody know where in the UK I can get a decent selection automotive wiring? I want to build my own harness from scratch, in OEM colours (so the damn wiring diagram makes some f****** sense) and this needs some two-tone wires. Can't find a supplier who will do these. Need to be ble to...
  4. Tech Discussion
    Anybody know how to remove the reverse lock-out cable from a '65 Mustang 4-speed shifter? Cheers, Mark.
  5. Stuff - WANTED
    Hi looking to see if anyone has a lokar throttle cable surplus to needs. I need really the bulkhead to carb part only and fittings for the carb. (if i buy a new one the rest will not be required) Also looking for a 7lb or 15lb radiator cap for a walker rad. Alternatively does anyone know a...
  6. Stuff - WANTED
    Hi all, I`m looking for a good B & M Shifter Cable. This is the Precise Shifter that I want it for ; - http://www.bmracing.com/SPECIALS/Street-Bandit-Hi-Tek I purchased this very recently from another R & S Member, and it is absolutely fine, but unfortunately, the Cable that is supplied with...
  7. Vehicles - WANTED
    Hi all, I`m looking for a good B & M Shifter Cable. This is the Precise Shifter that I want it for ; - http://www.bmracing.com/SPECIALS/Street-Bandit-Hi-Tek I purchased this very recently from another R & S Member, and it is absolutely fine, but unfortunately, the Cable that is supplied with...
  8. On Topic
    who sells rover speedo cables 1972 3.5 auto.any ideas please.
  9. On Topic
    I want to run some armour plated cable to the new garage, so what core size should I look for? I'm looking at the 3 core black steel bound stuff http://www.tlc-direct.co.uk/Products/SW4slash3.html as it will sit above ground (it has to run around the side of the house & up garden) so it will be...
  10. Tech Discussion
    wiring time and need to buy some connectors etc what size cable do i need for my battery to starter battery is in in the rear of the car so about 3m ish long
  11. Tech Discussion
    I just saw Farncombe Pop's post on NSRA site, looking for a cable for Jag IRS, I think you're sorted now? Anyway, I found that a Morris 1000 cable was perfect for the job, (on my Pop). it even has a built in bolt, so you can fix it to the chassis. My handbrake was still 'kin useless, but the...
  12. Stuff - WANTED
    AS IT SAYS IN THE TITLE. LT77 GEARBOX TO STEWART WARNER SPEEDO CABLE. 01304831064 / 07749264536 www.scavengersrodnkustoms.piczo.com
  13. Tech Discussion
    What speedo cable would i need to fit a Mk2 Zephyr dash to Type 9 Gearbox??or would it have to be custom made?? Cheers Greg
  14. Stuff - WANTED
    Looking for a flathead banjo speedo cable, also looking for a flathead speedometer
Top