Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. Tech Discussion
    Hi All Iv,e been offered a front crossmember from a 16 capri to fit in my lads 300e I under stand there are going to be some problems fitting. I need to know just how much and would I be better going for a mk2 I realy don,t want to waste my lads money I keep getting conflicting info, I intend to...
  2. Stuff - FOR SALE
    jig to pancake rear crossmember for 35-40 ford. it holds the outsode edges and center section at the right angles so you can cut it apart and put it back together. No use to me anymore, so if you want it, its free.
  3. Stuff - WANTED
    Desperately need as title - this is for a front suspension rebuild - i want to build it up off the car but still drive the car, plus i can powder coat it etc then swap the lot over in one day. So I could even borrow yours and exchange it for the one on the car if you get my drift? Watcha got...
  4. Stuff - WANTED
    Wanted..... Ford Model A rear crossmember. This post is for a friend, please contact him direct, Call Nick on 07966 584805
  5. Stuff - FOR SALE
    As per the title , have a 107E front crossmember for sale , I think it's a direct bolt in for 100E so you can fit a pre crossflow motor . £25 Can take a pic if anybody needs one. Can post anywhere in the UK for £9 .
  6. Stuff - FOR SALE
    Anyone after a Pop front crossmember? Good condition, rusted but solid, has been sitting in my workshop for months as it came with the front end but I had no use for the crossmember itself. £15. I am near Yeovil in Somerset, PM if interested :)
  7. Stuff - WANTED
    As it says, 35-40 ford rear crossmember wanted
  8. Stuff - WANTED
    I'm after the rear crossmember for a 40 Ford Chassis, the one that holds the spring. I think 35 to 40 are the same, so an earlier one may do. Ta
  9. Stuff - FOR SALE
    hi guys, got a few bits for sale due to the direction change on the pop. one pair of sit up and beg pop doors, both in good condition one has a dent in the top, some surface rust and a small hole or two, the other a couple of dings, small holes and needs a small repair at the bottom £120 for...
  10. Stuff - FOR SALE
    SEALEY SUPERMIG 150/5 MIG WELDER Welding current 30-150A A forced air cooling system to slow transformer heating and increase duty cycle It has a good non-live torch to prevent accidently striking an arc It has speed control for the wire feed and ampage control Chain on the back for securing...
  11. Tech Discussion
    Before i fit up my ifs and crossmember would i be right in thinking that you would lay it back somewhere between 4 and 7 degrees the same as you would do when mounting a tube or i beam axle. Obviously it will be all set up at ride height initially before mounting crossmember. Thank you
  12. Stuff - WANTED
    wanted a model a front crossmember, must be in good condition or new replica andy
1-12 of 12 Results