I have started rebuilding the heads on my 351 ford windsor engine today but have just realised that there are 2 different lenghts of valve springs. The longer ones have a fixed cotter retainer and the shorter ones have a cotter reatainer that can rotate but I do not know which ones go on what...
:PJust purchased a good condition of double bump fulie heads of ebay (saturday nite alcho racing),and wondered if any body had experienced any problems with fitting them ect,any help or hints or tacking piss accepted.:tup: the casting numbers are 3890462 not sure of valve size as they are at...
wanted a pair of pontiac v8 cylinder heads stamped 6x - 4
complete or just head castings as long as reconditionable
rockers, valves , springs etc not important
some one must have a set in back of the shed !
dont really know if this is the place to post this, but i came across this website in my skin deep tattoo mag and it just rocks, though id pass it on.. www.shrunken-head.com the dude makes shrunken heads to suit what you want, even makes smaller ones to hang on your rear view, would...
Unmachined small Ford block (`72 I think) Bores still mic at 4" exactly also 302 crank (decodes as `69 Mustang) that hasn't been machined either. Been stripped & stood for a long time so covered with surface rust. There are pistons , timing housing , sump etc with it but no heads. £100
I have a matching pair of SBC early 350ci cylinder heads, came off a running engine, vgc & complete .... just need a clean up.
Head Cast No 3998991
Consider deal for decent aftermarket SBC alloy intake.
Collect sussex area.
1971 440RB block, bored, just needs finish honing to your ring choice, main caps and bolts included, oil pickup taken out to 1/2
forged steel crank, has been fully machined, 3.750 stroke
hemi rods with bushed pin end for fully floating wrist pin, arp bolts and 12point nuts installed
Pair ZZ4(Sports truck application)big block chevy heads,look to be in good condition,was told engine had done 30 thousand miles ish,if you want them make me an offer, not looking to retire on the proceeds,Bry
I have for sale 350sbc heads from a goodwrench engine complete with rockers.They have done under 6000 miles and came from Bob Booths model a.I have replaced them with dart heads,so no longer needed.I am looking for £300 ono
Chris 01708 890524 mbl 07802 256553
I have a set of L98 (zz4) Aluminum heads from a low mileage corvette. Good heads for 283, 305, 307, 327 and 350. They flow good and have 58cc chambers so will give your compression a bump and save a bit of weight . Comes with valves and springs just need rockers £250
Brand new Comp cams 1.52...