Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1-12 of 12 Results
  1. On Topic
    Looking for someone who can put a couple of shallow (15-degree) bends in 2.5" steel pipe. I live near Newmarket but also travel to Ipswich quite regularly, so any recommendations...? :tup:
  2. Tech Discussion
    Jaguar rear calipers needs bubble flare brake pipe ends to seal properly. I have been told two different ways to make these flares: 1. Buy a bubble flare tool. 2. Use the more common 45 degree inverted flare tool and skip the last operation (the one that inverts the flare). I have a good 45...
  3. The Garage
    Been collecting parts for this for a while and as things for other jobs dident turn up today I started this instead
  4. Tech Discussion
    How is the pipe fitted into the tank does it just push in ? looks like there is no clip or anything to hold it in ! Mick
  5. Stuff - WANTED
    Hi all, As it says above, it must be able to bend up to 2 1/2" pipe. I'm not holding out too much hope, WHY? Cheaper the better, or if anyone know swhere you can buy a new one cheaply. Cheers, Stu.
  6. Stuff - WANTED
    My mates after a front sump and pick up pipe for a V6 Essex engine. Can anyone help? greenfordpop AKA Barry
  7. Stuff - FOR SALE
    staffer pipe bender +all formers ideal for making roll cages.boxed.collection from my place as its a heavy mother £80 email [email protected] phone 07966 915749
  8. Tech Discussion
    Does anyone know a cheap source for a 37 degree brake pipe flarer. Going to try the local hire shop/Pirtek but not holding my breath. Gutted if I have to buy the tool as I only need two ends flared for me new linelock :D I know Speedflow hire one out/flare ends but by the time it's all costed...
  9. Tech Discussion
    I need to make up an exhaust system or 2 and some headers. I've seen the drybolic type pipe benders with a bottle jack in them, and seen them used on normal exhaust pipe and they dont bend the pipe they just fold it wich is obviusly no kin good:tdown:. So what pipe should I be looking for ( cds...
  10. Tech Discussion
    Hi guy's going to split the headers on my 235 chevy,is there any point in putting a balance pipe in,never bothered with one before just wondered if it's worth the hassle? Also want to run a pair of Smithy's,does anyone know who stocks em :tup: Cheers
  11. Chat
    I hoping someone can help me. I have an Essex 3Ltr V6 in my pop and I am guessing a Capri Radiator. I changed the Radiator Cap to a nice Chrome Ford one and I don't know if it was coincidence but it started to lose a lot of water. No head damage etc but I filled it up again and it still over...
  12. Stuff - WANTED
    Wanted servo pipe union V6 Essex or similar (the screw in one from the inlet manifold, needs to be for an auto box and has the extra little pipe for the auto box modulator vacuum. Cheers
1-12 of 12 Results