Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1-2 of 2 Results
  1. Tech Discussion
    Hi all. I know I asked a similar question to this a few months ago asking about changing the rear crank seal on a sbc whilst the engine is in situ. To be honest I haven't gotten round to changing it yet hence the new enquiry. When changing these seals do they have to be replaced like for like...
  2. On Topic
    ...installing Teflon valve stem seals? Getting these friggin' tight little bastards on without damaging anything must be the worst job in the world! Does anyone do this for a living? Do you enjoy it? I only had to do four of 'em this time (V-twin motor) but that stupid little plastic guide...
1-2 of 2 Results