So i have an 81' vette with a 383 stroker ready to go in.
I went to town on this engine the only thing original is the block.
I want to upgrade the TH350 i now have (not TH350C i got rid of that S**t) to hold up to the 400+bhp & 400+ft/p torque i will be producing.
I know first i...
Just signed up as its nice to see somewhere in the UK where people have an interest in parts I need and have to sell. Mainly American.
My names Scott im 26. I am a senior engineer for a maintenance company in the midlands and before that I did my time as an Electrician/Electrical...
1950 Vauxhall with 5.7L engine (correctly registered V5C stating this).
Complete box section rolling chassis.
Fitted with a new 350 (4 bolt main 5.7L) Chevy crate motor (never been started), Edelbrock Performer inlet manifold, Holley carb, Mallory distributor, Champion spark plugs...
Chevy TH350 long tail shaft, including Converor, been sitting on the shelf for awhile, (Dry of course) been told it's rebuilt but never fitted, bought from a mate who purchased it from a guy who once owned Andromeda & Revenge
at the same time 8)
Will deal Chevy 4 speed manual :tup...
Bit of a clear out! 1967 small journal 327 rebuilt many years ago. Never run or completed. One journal will need re-polish as damaged. Rebored +40. New cam/lifters.
2 sets chevy heads - nothing special. One set with screw in studs and valves.
TH350 cut-out complete with Torque...
End of a prop with a billet end with slider for a TH350 and i think fit a glide but check first. Very strong as can imagine. £40 no offers. 07792746357 Can take to sawp meet, But im leaving sat around 3pm so must know before hand. Thanks Adam.
Hi there, I am looking for a Chevy Small block and auto box TH350'ish don't mind a bit of work as it will be going in an on going project also don't need it next week (not urgent) and could poss !! take out of vehicle but better if it's on the floor :),
It's going in a rat project so it don't...
Which would you use and why ?
Lets say just for an example daily driver (rwyb :tup:) behind either sb/bb chevy (nothing special)
And yep i know that th350 are mainly for sb but personal knowledge of one thats lasted 13+yrs on a big block and driven hard
700R4 with out all the gubings but...
anyone got an auto shifter to fit a th350 or an old hurst po matic ratchet shifter to repair mine, gbox bkts , cover etc. anything will help .
also will be looking for a pair of 12x15 rims . centerline would be good but consider anything (when fund tops up) , would be cool if they got rollers...
As it says above, I need the gear linkage cable or rods from a B&M click shift to the TH350 gearbox. Are these expensive new and does anyone know where I can get them, if not I would be happy with a good secondhand set.
How easy is it to set up the linkage for the autobox?
Is it possible to run a rod rather than a cable?
If I shortened the linkage would this cause gear selection problems?
Just trying to sort out a gearbox mounting issue with out having to cut the car up too much. All help is...
Need a diagram as i want to get the kick down working on my trans but someone (not me) has snapped the little bar that opperates the kickdown cable in the box
Also needed is THAT little bar :shake: