Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
183 Posts
Discussion Starter · #1 · (Edited)
Hi all just feeling if there was any interest in my Original All steel bodied Model T tourer Body
Body in VGC have welded 2 patches onto it since i bought need 1 small patch to the drivers side rear
Comes with front wing, two sets of rear wings running boards headlamp holders grill and radiator roof brackets instrument cluster
2 x sets of chassis rails, one with running board riggers and supports the other in VGC and bare so great to swap over
No rot in bottom of the doors bulkhead in great condition non molested - LHD
Have rubbed down and sprayed the body in protective primer
Windscreen and posts - upper screen missing though
Comes with Front Axles and Rear Axles with wheels off a 1948 alvis ta14 inluding all brakes (Rod - Levers) and suspension components, springs etc i was planning to build this up with
2 litre Pinto - was running six months ago with 5 speed MT75 gearbox
No Diff though i suppose this would be easily enough to figure out
Steering box and wheel though not fitted

Obviously not going to be driven away, Axles are only placed to allow it all to roll will need work but will be one great looking rod
No pedals, No bonnet, No Docs but a great all steel rod to work on looking for £2500 thanks
please PM for details

only selling as my Alvis build is taking over thanks






Before spray


 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top