Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,420 Posts
Discussion Starter · #1 · (Edited)
please note this case and shafts come with a different pair of bearing housings that have 2.5 inches of tube - you will need a half inch to weld to this case.
or spin it all off and nibble 1/2 inch from that shafts and get 53 inches wide
ideal in a model a

non taper tube 8'' small bearing 28 spline

takes 10'' brakes

collect or may post in bits






if you look at the shafts above they touch, there is another pair of axle tube ends with 2.5 inches on them, you only need 1/2 and a smidge.
 
1 - 1 of 1 Posts
Top