Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
477 Posts
Discussion Starter · #1 ·
Mustang 8” rear , with stock drums, I’m after the brake fittings for the 3/16 pipe to slave cylinder, and idea who supplies these , I found them on eBay but I want to know they are good quality
 

·
Registered
Joined
·
1,469 Posts
Woodie, the American UNF fittings are different to the British ones. Post a link to the ones you have found. I have some here and I am local, PM me if you want them.
 

·
Registered
Joined
·
1,469 Posts
I have no idea on the quality but they are the American type, fully threaded without the nose that the British have.

Is the thread 7/16th or 3/8th?

Cheaper in bulk.


Or
 

·
Registered
Joined
·
477 Posts
Discussion Starter · #5 ·
I have no idea on the quality but they are the American type, fully threaded without the nose that the British have.

Is the thread 7/16th or 3/8th?

Cheaper in bulk.


Or
According to what I’ve read on the mustang forums which may be incorrect is should be 7/16 , I will go down the garage this evening and measure them
 
1 - 5 of 5 Posts
Top