Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter · #1 · (Edited)
I have 3 door Cosworth 4 pot calipers up front and 285mm discs with Sierra rear calipers and Fiesta discs, running a servo on my Corsair. Having problems with master cylinder sticking at the present so planning a change to a new one (re-rubbered but no difference) so what size should I be looking for in a new master cylinder please? Would like to get rid of servo too so what size then? Paul
 

·
Off the Xmas card list
Joined
·
24,276 Posts
You'll hav eto completely redesign your brakes if you want to lose the servo as the m/c bore required will not create enough line pressure. Normal way would be tiwn cylinders on a bias box.

I take it you are currently running single circuit with remote servo ?
 

·
Registered
Joined
·
120 Posts
Discussion Starter · #3 ·
Yes single circuit, losing servo not high on the list just want empty engine bay. Will just locate it elsewhere. Do you reckon a one inch cylinder will work OK?
Got 7/8th one on at present. Paul
 
1 - 3 of 3 Posts
Top