Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
737 Posts
Discussion Starter · #1 ·
Hi i have fitted some new window channel in my ford f350 truck but the glass is very tight when i wind them up and down.I did some repair work on the door channels so i must have made it smaller.So can i grind,rub sand polish the door glass edge.It has rounded edges.I need about 2 mm taking off.There is a name on the glass but i think its in dutch so it might be toughen glass thanks again
 

·
Off the Xmas card list
Joined
·
24,496 Posts
I've known people manage to SLOWLY thin toughened glass but it can set up heat stress and make it pop for no ( apparent) reason. when no one is even stood by it. 40 grit on a DA with water soaked rag near edge to stop heta spreading. Eye and breathing apparatus neccesary .
You could give silicone spray in the channels or melted candle wax a try first.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top