Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Does anyone have any advice on the removal of the the door hinge pins on an F1 stepside, I am fitting new swan neck mirrors and they fit through the top hinge bolt, The old pins are a swine to remove, I have added some heat and the weight of a hammer but no joy!!!
Andy
 

·
Premium Member
Joined
·
4,207 Posts
Moved to correct section for you, Bry
 

·
Registered
Joined
·
1,987 Posts
carefully drill the bottom of it out, there are splines on the bottom which are about 8mm long and its these which dig into the hinge and hold it in place. once you get rid of those it should hammer out.
 
1 - 8 of 8 Posts
Top