Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner

1 - 2 of 2 Posts

·
Slowly but surely
Joined
·
951 Posts
Discussion Starter · #1 ·
My plans for a simple exhaust system utilising the old ram-horn manifolds went out the window and I ended up ordering headers, collectors, mufflers, pipe and butt-joint clamps direct from Summit.

Now, when I go to put it all together, everything but the mufflers are 2.5" OD, whereas they're 2.5" ID (and a gernerous 2.5" at that) :shake:

I have some U-bolts but the mufflers don't have any slots cut into them to suggest a compression joint would work - any suggestions...? Cut my own ? Buy lap-joint clamps ?
 

·
Registered
Joined
·
5,698 Posts
Cut your own slots, will be easier in the long run, or purchase some weld on three bolt flanges...???
 
1 - 2 of 2 Posts
Top