Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner

1 - 6 of 6 Posts

·
complete knob..apperantly
Joined
·
617 Posts
Discussion Starter · #1 ·
gonna try build my own cab/bed loosely based on a model a 1928/9.......sitting on a scimatar chassis, anyone help with some general sizes eg height width ,cowl drawings door sizes???/
off work with dreaded pig flu so having plenty of time to draw and work things out
cheers in advance paul
was gonna pop round measure yours kev just been not well :sniff: lol
 

·
Off the Xmas card list
Joined
·
24,099 Posts
Yup, you can stay WELL clear with that thanks ! Once you have the all clear feel free to pop by.
 

·
complete knob..apperantly
Joined
·
617 Posts
Discussion Starter · #4 ·
anyone got width off firewall.... across top and bottom height.....screen size approx..........length off cab from firewall to rear of cab....

bump ..... still house bound :sniff:
 

·
Off the Xmas card list
Joined
·
24,099 Posts
I can do the bulkhead to rear of cab without even looking ...48 inch and it's a tad too small , add another 4 inches to a roundback ( approx 50" as standard) or 6 inches to a flatback and there's loads of room ( relatively).
Bulkhead is difficult as it curves all round.

I'd start with a grille and work back ,ie flat sidepanels , Model A are 29 inch and where they end up is where you need to start thinking about bulkheads.

Which Scimitar have you got as they have different wheelbases?
 

·
complete knob..apperantly
Joined
·
617 Posts
Discussion Starter · #6 ·
its a later one kev se6?....was gonna make as roomy as possible,
if i feel better or passing over weekend may pop in :tup:
 
1 - 6 of 6 Posts
Top