[mygasser]

to locate the t/c in the box gently push it in while turning it with the other hand. it should go in in three distinct steps to be fully home. a wiggle with the pushing hand while turning helps. if you're unsure measure from the t/c mounting face out to the bellhousing front face (use a straight edge across the bellhousing). then measure from the back face of the block to the back side of the flex plate where the t/c mounts. the box measurement should be very slightly larger so the t/c pulls forward away from the t/c seal as you do up the t/c to flexplate nuts/bolts. hope that makes sense. neil.