Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1 - 4 of 4 Posts

1,231 Posts
Discussion Starter · #1 ·
Does anyone know where I could get a neat, rolled edge done on some long strips of thin stainless?
I'd like to make a pair of these vent shades for a 57 Chevy, the 2 door hardtop ones are very rare and tend to go for silly money. They look easy enough to make if I can get the rolled edge done.

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.