Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
226 Posts
Discussion Starter · #1 ·
I'm getting close to installing the seatbelts in my project, I was hoping to reinstall the original inertia type belt but there is no room at all between the seat and the B pillar. The closest I can get is around 100mm further towards the rear of the car which l assume will be fine but I won't be able to tilt the inertia unit towards the shackle at the top of the B pillar so would imagine I need a unit from a car that was set up like this from the factory? Is there any other options other than wandering round a scrapyard looking for a similar set up? The only example that springs to mind is a MK1 or 2 Fiesta which may be the way to go but any help greatly appreciated.
 
1 - 6 of 6 Posts
Top