Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1 - 3 of 3 Posts

·
Global Warmer
Joined
·
1,201 Posts
Discussion Starter · #1 ·
Must be a mini starter due to space constraints.

Dual pattern or staggered.

Have a practically brand new straight mini starter for sale or swap.

P.:D
 

·
Registered
Joined
·
340 Posts
Drill block for starter... no brainer

Must be a mini starter due to space constraints.

Dual pattern or staggered.

Have a practically brand new straight mini starter for sale or swap.

P.:D
Hello Paul... load your stater with 1 bolt.. to block , square it up to edge of block @ rear... tighten bolt good... now take 5/16 dia drill use starter bolt hole as guide.... drill right through flange in block... take 3/8 NC tap tap hole you just drilled... blow out hole ,,, load new bolt... job done...
Done this 100's of times with GM blocks not drilled for straight bolt pattern
YES the do sell staggerdd mini's BUT THERE PRICEY.... :eek: not needed
Cheers!... Daryl
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top