Rods 'n' Sods banner

1 - 13 of 13 Posts

·
Registered
Joined
·
1,420 Posts
Discussion Starter #1 (Edited)
et centre caps new £ending on ebay today!!!

these are 1.1/8 between holes, i need 2.1/4 - will swap you, even for plastic ones to fit are torque thrusts

31 spline shafts fat ones £ending onebay today -
-----------------------------------
8 inch case £90 - mustang 2 tapered ends
===================================
4 stud shafts for above £60 -28 spline small bearings
strange shafts = 30 inches wheel flange to flange, small bearing and 31 splines £90
same but resplined stock 31 splines big bearing £50
2 9 inch half shafts with stock disc brakes = lincoln £75

holley 600 vac sc £50
elite cleaner round £15
xr3 rack £25
cortina rack or escort? £35
10 m12 by 1.5 weld nuts £15
10 1/2 inch unf lug nuts £15 -with washers
m12 studs long £1.50 each
m14 by 1.5 studs £1.50 each
m14 button head wheel nuts not 60 degree taper chrome £1.50 each
m14 socket caps 12.9 din 912 40mm long £1 each-with nylocks
mustang 2 front spindles £40 a pair
gm mid 80's calipers and stang 2 adaptors £45 - front ones

th350 transission £125
custom dash £25
cayenne rear calipers £250 = 4 pot brembo
set of 996 calipers porsche brembo 4 pots £550
996 servo £100 comes with mc and prop valve

west london
 

·
Global Warmer
Joined
·
1,200 Posts
How wide is the 9" case?

Is it the smooth round one or the later casing??

P.
 

·
Registered
Joined
·
1,420 Posts
Discussion Starter #3
its a late heavy duty one big bearing
1 peice bearing -heavy duty
with the notch for the 9.3/8 ring gear too
0very wide
 

·
Registered
Joined
·
3,207 Posts
are the tubes on the case round or flattened at the top for spring perches, if round im interested.
 

·
Registered
Joined
·
1,420 Posts
Discussion Starter #6 (Edited)
Is the 30" measurement on the strange shafts overall length?
yes wheel flange to flange, with an inch in the middle
-total width, centred pinion = 30 inches
small beaing 31 splines
strange, alloy retainers
4.5 inch pcd, bolts for studs

the distance from where the bearing sits in the case to the ends is 15 inch and 10.5 inch
-so add the flange to the bearing, 2 inch a side, plus the 1 inch for the diff space/
 

·
Global Warmer
Joined
·
1,200 Posts
If you have a pick of the casing before I make arrangements to come over that would be useful

P.
 

·
Registered
Joined
·
1,420 Posts
Discussion Starter #13 (Edited)
hello there, no prop
-the guy on nhere breaking the stang 2 has one though, i just got the axle from him,

however....
there is a u/j available on the speedways website, that converts a chevy prop uj to ford
 
1 - 13 of 13 Posts
Top