[sqweaka]

are the US five stud ford pattern the same as mk2 granada or will it need re-drilling

 

[chevy2]

The common US ford 5 stud is 5 x 4.5", same as mk 2/3/4 zephyr,
granada is metric, about 2mm? different,
can't remember if its bigger or smaller but yes you'll need to redrill your hubs.

 

[sqweaka]

ok any idea how much that would cost to get done

 

[trevd]

im sure a local small engineering shop could do it for sensibvle cash, i would charge about £30 but the postage would make it unfeasable to do, try looking in the yellow pages, you must have some small firms near you that would do it for cash.

 

[chevy2]

A guy local to me has done a few sets of granada hubs to US 4.5" 5 stud,
bit involved i think as the original holes need milling out to the correct bolt circle, then top hat type spacers made to go in these holes for the new wheel studs, dont think you can simply redrill between the existing holes as the back of the studs foul on the calipers, the original studs are recessed into the hubs and sit flush to the inside face,
think my mate charged about £100.00 as it's not a quick simple redrill,
but once again you'll probably need someone more local.