Rods 'n' Sods - UK Hot Rod & Street Rod Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
923 Posts
Discussion Starter · #1 ·
Anyone able to tell me how to or supply me with a piece of sheet that's folded 90 deg then curved? I don't want to make lots of little cuts then weld them up to create a curve. Thanks
 

·
Registered
Joined
·
947 Posts
If you have the sheet bent a 90 degrees you then hammer on one of the sides and the metal will bend without cutting, bends because you are stretching one side and therefore the other has to bend, last time I did any of this was at college, so long ago I can only just remember the process. Good luck.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top